Ghost Rider Auto-Stroking Cup: How to Use and Clean It

Quick answer

To get the most from the Ghost Rider Auto-Stroking Cup, start with a low stroke speed and moderate vibration, use plenty of water-based lube, and clean the TPE sleeve immediately after each session with warm water and mild soap. The steps below cover setup, hands-free positioning, and safe cleaning.

Step-by-step: setting up, using, and cleaning your auto stroker

1. Charge fully before first use: Connect the magnetic charger and let the cup charge for up to three hours. A full charge gives at least 1.5 hours of continuous use. Common mistake: assuming a partial charge is enough for a long session—top up if the motor slows or vibration weakens. Charge the night before rather than relying on a quick top-up.
2. Apply water-based lube generously: Add a few drops of water-based lubricant inside the channel and on yourself. Silicone-based lube can damage the TPE sleeve. Checkpoint: if the stroke feels draggy, add more lube rather than increasing speed.
3. Start with low stroke speed and mild vibration: Turn on the cup and cycle through the five stroking modes to find a slow, steady rhythm. Then try the ten vibration frequencies one at a time. Common mistake: jumping to the highest setting immediately, which can feel numbing rather than pleasurable.
4. Preheat if you want a warmer feel: Activate the heating function and wait for it to reach around 40°C. You can adjust warmth manually or via the app. Checkpoint: do not use heating for more than a few minutes before play if you are sensitive to warmth—start with the lowest heat setting.
5. Try hands-free positioning: The cup weighs about 800 g and measures roughly 30 cm long, so it stays put on a flat surface or between cushions. Lie back and let the stroking motion do the work rather than gripping tightly. Common mistake: holding the cup too rigidly, which reduces the hands-free benefit and can tire your arm.
6. Explore app control or partner play: Pair the cup with the app to adjust heat or hand over control to a partner remotely. Checkpoint: agree on limits and a safe word before handing over control, especially if you are new to remote play.
7. Clean immediately after use: Turn the cup off, remove the sleeve opening if applicable, and flush the inner channel with warm water and mild soap. Wipe the outer shell with a damp cloth—do not submerge the device. Rinse thoroughly and let all parts air-dry completely before storing. Common mistake: skipping cleaning because you plan to use it again soon; dried lube and residue are harder to remove and can harbor bacteria. Set a timer or place a drying rack nearby so cleaning becomes automatic.

Product facts

• Ghost Rider Auto-Stroking Decompression Cup: Five stroking modes and ten vibration frequencies can run together. You can start with one sensation at a time and layer the second once you know your preferred intensity.

  

• Ghost Rider Auto-Stroking Decompression Cup: Heating reaches 40°C ±3°C and can be adjusted manually or via the app. Preheating before use reduces the cold-start sensation, and app control lets a partner adjust warmth remotely.
• Ghost Rider Auto-Stroking Decompression Cup: The TPE sleeve is soft but not removable; the outer shell is splash-resistant and the inner channel can be rinsed. Cleaning means flushing the channel and wiping the shell, so avoid submerging the whole device.