Black Hole Pro Care: Cleaning and Drying Routine

By JoyStick | Discreet Adult | Published: 2026-11-03

Category: เคล็ดลับและการดูแล

Keep your Black Hole Pro-Automatic Drying stroker in top shape with a simple cleaning, drying, and storage routine that protects the motor and soft liner.

Quick answer

Clean the removable soft liner with warm water and mild soap after every use, let it air-dry completely or use the heated drying base, and store the unit with the liner removed to prevent moisture damage.

Why the drying base changes your routine

The Black Hole Pro-Automatic Drying model includes a 38.5°C constant-temperature heating base that also supports automatic drying. That means you can skip the usual towel-dab and long air-dry wait, but only if you remove the liner first. Leaving the liner inside while the base runs traps moisture against the motor housing and can shorten the life of the electronics.

Even with the drying base, always unplug the unit and let it cool before wiping down the exterior. The base is designed for drying the liner and interior, not for washing. Never submerge the main body or the base in water.

When to replace the liner instead of cleaning it

The Black Hole Pro uses replaceable soft liners in three sizes (basic, tight, and comfortable). If you notice tears, sticky residue that won't rinse away, or a persistent odor after cleaning and drying, replace the liner rather than trying harsher chemicals. Harsh cleaners can degrade the soft rubber and make the texture less pleasant.

Keep a spare liner on hand so you're never tempted to skip cleaning because you want to use the device right away. Rotating between two liners also gives each one more time to dry thoroughly.

Step-by-step cleaning and drying routine

1. Power off and disassemble: Turn off the device, unplug the magnetic charging cable, and remove the soft liner from the main body. Separate the liner from any inner sleeve or texture insert according to the liner type. Never clean the device while it is charging or plugged in.
2. Rinse the liner: Rinse the liner under warm running water to remove loose residue. Avoid hot water, which can warp the soft rubber. Check the water temperature with your wrist before rinsing—it should feel lukewarm, not hot.
3. Wash with mild soap: Apply a small amount of mild, fragrance-free soap to the liner and gently massage it inside and out with your fingers. Do not use alcohol, bleach, or abrasive cleaners. If the soap leaves a slippery film, rinse longer—residue can irritate skin.
4. Rinse thoroughly: Rinse the liner under warm water until all soap is gone. Pay attention to the inner texture channels where residue can hide. Hold the liner up to a light to check for any remaining soap bubbles.
5. Shake off excess water: Shake the liner gently to remove most of the water, then pat the outside dry with a clean, lint-free towel. Do not wring or twist the liner. Avoid using paper towels, which can leave lint inside the texture.
6. Use the drying base: Place the damp liner on the heating base (or according to the manual's instructions) and turn on the drying function. Let it run for the recommended cycle or until the liner is completely dry. Do not leave the liner on the base for extended periods after it is dry—overheating can degrade the material.
7. Wipe the main body: While the liner dries, wipe the exterior of the main body and the base with a soft, slightly damp cloth. Do not let water enter the charging port or seams. Use a cotton swab to clean around the magnetic charging contacts.

Product facts

Black Hole Pro-Automatic Drying: Includes a 38.5°C constant-temperature heating base that supports automatic drying. You can dry the liner faster and more thoroughly than air-drying alone, but only if you follow the correct sequence.
Black Hole Pro-Automatic Drying